-1- IINNSSTTAALLLLAATTIIOONN AANNDD PPRROOGGRRAAMMMMIINNGG MMAANNUUAALL FFOORR PPRROOGGRRAAMMMMAABBLLEE TTIIMMEERR ((MMOODDEELL LLPP--22)) FO
-10- every 3 days, and will last for 18 days (6 x 3 = 18), not counting Saturday and Sunday. Minutes per dB help screen Press 0 (for the menu scree
-11- other values will be set to their default values. These default values are listed below. INITIAL DEFAULT VALUES Default attenuation values a
-12- Default minutes per dB values after a reset Zone 1 and 2, Monday through Sunday inclusive. 12:00 AM 5 Min/dB 1:00 AM 5 Min/dB 2:0
-13- used by default. Acclimate dB's = -6 Days per dB = 3 The date and time will need to be reentered after a reset. SPECIFICATIONS Power r
-14- 7:00 AM 8:00 AM 9:00 AM
-15- 8:00 AM 9:00 AM 10:00 AM
-1-
-2-
-2- Copyright © Lencore Acoustics Corp. All rights reserved. April 2000 CCOONNTTEENNTTSS Introduction 3 Display 3 Keyboard
-3- Notes 15 Menu flow chart 16 INTRODUCTION The Lencore Model LP-2 Programmable Timer is a two zone electronic attenuator when
-4- On line 3, Z1 refers to Zone 1, Z2 refers to Zone 2. The current values in dB's are shown for each zone. These values are referenced to an
-5- The two zones must remain separate. If there is only one zone to connect to the timer, leave Zone 2 unconnected. This is very important. 3.
-6- steps. 7. Locate the Test/Normal switch on the P.C. Board. Put the switch in Test position. The display will change showing both a dB level a
-7- Press 0 Press 0 Daylight savings Press 0 (for the menu screen) Press 2 Press 2 Press 1 to enable, or 2 to disable Press 0 Press 0 Press 0 To l
-8- Press 0 Press 0 Press 0 Press 0 Change minutes per dB Press 0 (for the menu screen) Press 3 Press 1 for Zone 1, or 2 for Zone 2 Press 1 for Mon
-9- Turn on acclimate Press 0 (for the menu screen) Press 4 Press 1 Press 1 Press 0 Press 0 Press 0 Turn off acclimate Press 0 (for the menu screen
Comments to this Manuals